Airborne Noise Emission The A-weighted sound pressure emitted by this product is below 70 dB. ** The noise level can vary depending on the site. The figures quoted are emission level and are not necessarily safe working levels. Whilst there is a correlation between the emission and exposure levels, this cannot be used reli- ably to determine whether or not further precautions are required.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. Always comply with the following precautions to avoid dangerous situations and ensure peak performance of your product WARNING It can result in serious injury or death when the directions are ignored CAUTION It can result in minor injury or product damage when the directions are ignored WARNING...
Page 4
IMPORTANT SAFETY INSTRUCTIONS • When installing and moving the air conditioner to another site, do not charge it with a different re- frigerant from the refrigerant specified on the unit. - If a different refrigerant or air is mixed with the original refrigerant, the refrigerant cycle may mal- function and the unit may be damaged.
Page 5
IMPORTANT SAFETY INSTRUCTIONS • Do not use the product for special purposes, such as preserving foods, works of art, etc. It is a consumer air conditioner, not a precision refrigeration system. - There is risk of damage or loss of property. •...
Page 6
IMPORTANT SAFETY INSTRUCTIONS • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Installation work must be performed in accordance with the national wiring standards by authorized personnel only. Please retain this installation manual for future reference after reading it thoroughly. MULTI V EEV KIT www.lg.com P/NO : MFL69268301 To Outdoor Unit To Indoor Unit Quantity(EA) APPLICABLE INDOOR UNIT...
INSTALLATION INSTALLATION 1. Mechanical Installation Installation location Drill 4 holes on correct position and fix the EEV kit with 4 screw(field supply) Select the installation method case1 or 2, depends on the installation condition. Case 1 To Outdoor Uni t To Indoor Unit Connection Ø6.35 *Do not install upside down.
INSTALLATION 2. Brazing Work Cable (5 000 mm) To outdoor unit To indoor unit To Outdoor Unit To Indoor Uni t Brazing Brazing Pipe size Ø6.35 mm(1/4 inch) CAUTION • Make sure that the other parts such as electrical box, tie wraps and wires protected from direct brazing flames during brazing.
Page 10
INSTALLATION 3. Thermal insulation of refrigerant piping Be sure to give insulation work to refrigerant piping by covering with enough thickness heat-re- sistant polyethylene, so that no gap is observed in the joint between indoor unit and insulating material, and insulating materials themselves. When insulation work is insufficient, there is a pos- sibility of condensation drip, etc.
INSTALLATION 4. Electrical Work Open IDU Control Box Cover. Open fully indoor EEV through vacuum mode of ODU setting. Refer below contents. 2400 Step 3 1200 Step 2 Step Step 1 Step 1. ① Set ODU to “Vacuum Mode” (DIP switch 5 ↑ → SVC → SE3) ②...
Page 13
Representative: LG Electronics Inc. EU Representative, Krijgsman 1, 1186 DM Amstelveen, The Netherlands Manufacturer: LG Electronics Inc. Changwon 2nd factory, 84, Wanam-ro, Seongsan-gu, Changwon-si, Gyeongsangnam-do, KOREA...