Advertisement
Available languages
Available languages
17. F ully insert the ends of the front of the cab assembly into the ends of the
crossbar (J). Insert set screws (S) into ends of crossbar (J). With assistant
holding cab assembly horizontal to the ground, tighten all bolts and
set screws.
CAUTION: Do not overtighten the set screws.
18. F inish assembly by fastening all hook-and-loop straps inside the cab if
you have not already done so.
CAUTION: No cab fabric should be allowed to touch engine or exhaust.
19. T he cab is designed to accommodate snow blowers equipped with a
light. A zipper on the front of the cab can be opened and the flap pulled
back to allow the light to shine through. At this time, adjustments may be
necessary for free movement of operation controls.
20. F or storage, loosen the two set screws (S) in crossbar "J" and pull the cab up and out of crossbar "J." See Figure 17.
21. For cleaning, just use mild soap and water.
8
S
J
Advertisement
