Panasonic SV-AP10 Operating Instructions Manual page 35

5
6,7
(Figure1)
8,9
Connecting and Operating with a personal computer
Installing from the [Add Printer Wizard] screen.
Notes for Installation
When the Printer Driver is installed on your personal computer for the
first time, the USB port cannot be selected in the selection stage for the
port, because the USB port is not set.
Note that the [Add Printer] function can be used only when the Printer
Driver is re-installed or when another printer using the USB port has
been installed.
≥If the Plug and Play function activates the Install Wizard, install the
Driver in the Plug and Play mode.
≥If a screen asking you to execute a test print is displayed during
installation, select [No]. Carry out a test print from the Printer
Properties after installing the Driver.
≥For Windows XP
Select [Start] >> [Printers and Faxes].
[Printers and Faxes] may not be present on some personal
computers.
In this case, select [Start] >> [Control Panel] >> [Printers and Other
Hardware] >> [Printers and Faxes].
≥For Windows 98SE/Me/2000
Select [Start] >> [Settings] >> [Printers].
For Windows XP
1
Before installation, check that all applications have been
exited.
2
Connect the printer to your personal computer with a
USB cable and turn on the printer.
3
Select [Start] >> [Printers and Faxes].
[Printers and Faxes] may not be present on some
personal computers. In this case, select [Start] >>
[Control Panel] >> [Printers and Other Hardware] >>
[Printers and Faxes].
4
Select [Add a printer] from [Printer Tasks].
5
When the [Add Printer Wizard] is activated, click [Next].
6
Select [Local printer attached to this computer] and
remove the selection (un-select) [Automatically detect
and install my Plug and Play printer]. Please follow
directions in Figure1.
7
Click [Next].
8
Select [Use the following port] and select the port
through which the Printer is connected from the
adjacent list below.
≥Select [USB00X], for example [USB001].
9
Click [Next].
35