Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Fujitsu Manuals
  4. Laptop
  5. P1610 - LifeBook - Core Solo 1.2 GHz
  6. Technical procedure

Fujitsu LifeBook P1610 Technical Procedure

Display rear cover replacement
Hide thumbs Also See for LifeBook P1610:
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
LifeBook P1610
Display Rear Cover
ESD Precautions are required when working on this LifeBook computer.
Make sure the LifeBook is turned off before beginning this procedure.
1. Turn the LifeBook over and
remove the battery
3. Release the cable by flipping the
latch up.
Replacement
2. Extract these 3 screws from the
Hard Disk Drive cover and lift it off.
4. Lift the Drive out.

Advertisement

loading

Related Manuals for Fujitsu LifeBook P1610

Summary of Contents for Fujitsu LifeBook P1610

  • Page 1 LifeBook P1610 Display Rear Cover Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Extract these 3 screws from the remove the battery Hard Disk Drive cover and lift it off.
  • Page 2 5. Extract 11 screws from the lower 6. Extract 2 screws from the rear of case. the LifeBook. 7. Open the LifeBook and lay it flat. 8. Use a plastic pry tool to remove the keyboard upper trim. 9. Lift the top edge of the keyboard 10.
  • Page 3 13. Turn the Display back and lay it 14. Disconnect 2 Display cables from down. the system board and the 2 antenna cables from the WLAN Card. 15. Extract 2 screws from the Display 16. Lift the Display off the lower hinge.
  • Page 4 21. Lift the front cover off. 22. Extract 2 screws from the power switch board and turn it over. 23. Disconnect the 2 cables from 24. Extract 3 screws securing the the board and lift it out. LCD. 25. Tilt the LCD up turn it over and 26.
  • Page 5 29. Extract 2 screws from the 30. Disconnect its cable and lift the Fingerprint sensor board. board out. 31. Remove the tape securing the 32. Extract 4 screws securing the cables to the rear cover. hinge to the rear cover. 33.
  • Page 6 37. Insert the latch into the rear 38. Place the hinge cover onto the cover and secure it with 2 screws. hinge and secure the hinge to the rear cover with 4 screws. 39. Secure the cables to the rear 40.
  • Page 7 45. Connect the LCD cable and 46. Secure the LCD with 3 screws. place the LCD into the rear cover. 47. Connect the 2 cables to the 48. Secure it with 2 screws. power switch board and place it into the rear cover.
  • Page 8 53. Attach the 2 display cables to 54. Tilt the display up and rotate it ¼ the system board and the 2 antenna turn Cables to the WLAN card. 55. Slide the lower hinge cover into 56. Turn the Display back and lay it place.
  • Page 9 61. Insert 2 screws into the rear of 62. Insert 11 screws into the lower the LifeBook. case. 63. Insert the Hard Drive. 64. Press the latch down to lock the cable into place. 65. Replace the Drive cover and 66.