Download Print this page
Whirlpool FGP335BL2 Installation Instructions
Whirlpool FGP335BL2 Installation Instructions

Whirlpool FGP335BL2 Installation Instructions

30" freestanding gas range

Advertisement

Quick Links

7\
1
A
WARNING
1
I\
l
ALL RANGES CAN
TIP
-
'
l
INJURY TO PERSONS
COULD RESULT
l
INSTALL ANTI-TIP
DEVICE PACKED
WITH RANGE
l
SEE INSTALLATION
INSTRUCTIONS
IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer:
Leave
Installation
Instructions
and
anti-tip
bracket
template
with the
homeowner.
Homeowner:
Keep Installation
Jnstructions
and anti-tip
bracket
template
for
future reference.
Save Installation
Instructions
for local
electrical
inspector's
use.
L
/
Part No. 316002955/4372193
Rev. B

Advertisement

loading

Summary of Contents for Whirlpool FGP335BL2

  • Page 1 WARNING ALL RANGES CAN ’ INJURY TO PERSONS COULD RESULT INSTALL ANTI-TIP DEVICE PACKED WITH RANGE SEE INSTALLATION INSTRUCTIONS IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions anti-tip bracket template with the homeowner. Homeowner: Keep Installation Jnstructions and anti-tip bracket template...
  • Page 2 Before you start... Proper installation is your responsibility. qualified technician must install this range. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with the installation clearances specified on the serial/rating plate.
  • Page 3: Electrical Requirements

    Gas supply requirements Observe all governing codes and ordinances Fire Hazard Range must be connected to a regulated gas supply. L.P. gas supply must Not exceed a pressure of 14” water column. Thls must be checked by a qualttled technlclan betore lnstalllng the range.
  • Page 4: Gas Conversion

    16. 19. Numbers correspoi to steps. Place anti-tip wlth turned- bracket on floor up flange taclng the tront. Line up holes in anti-tip bracket with holes drilled in floor. Use screws to attach bracket to floor. Repeat with right anti-tip bracket.
  • Page 5 shutter 4. If air shutter needs adjusting, loosen air shutter set screw and adjust to obtain proper flame. This will normally completely open for L.P. gas. Tighten air shutter set screw. 5. Replace oven baffle and oven bottom. LA? to Natural gas Convertlng to natural gas should be done by a qualltled Installer.