Epson MOVERIO BT-30C User Manual page 3

Difficult to View the Screen in Bright Surroundings
You can view the screen easily by attaching the shade supplied. The
shade is magnetic and can be attached easily.
When Wearing over Glasses
By replacing the nose pads with the one supplied for glasses, you
can wear the headset over glasses. (The headset can only be worn
over glasses that are approximately 145 mm [5.71 inches] wide.)
• Make sure that you do not damage the glasses and the headset
when wearing.
• You may not be able to wear the headset over the glasses
depending on the shape of your glasses.
Remove the nose pads, and then attach the nose pads for glasses.
The nose pads for glasses is worn on the nose from over the
glasses.
If the Headset Does Not Fit Correctly
If the headset is loose and does not fit correctly, you can narrow the
width at the temples of the headset by using the temple adjustment
pads supplied.
Fold in the arms of the headset, and then stick the temple
adjustment pads to the outside of the temple section.
When Attaching the Lens to the Headset
You can use the lens holder supplied to easily wear the headset over
your glasses.
Have lenses inserted into the lens holder by your local optician,
and then attach it to the headset. (The cost of the lenses must be
borne by the customer. Depending on the optician, they may not
be able to provide this service.)
Lens holder adaptable lenses
Lens (W × H) 50 × 24 mm (1.97 × 0.94 inches)
Nose width 20 mm (0.79 inch)
Frame PD 70 mm (2.76 inches)
Curve 4
You may not be able to see images correctly if you use special lenses
such as colored lenses, mirrored lenses, or polarized lenses.
1
Remove the nose pads from the headset.
Grip the metal section of the nose pads between your
fingertips, and pull it straight in the direction shown by the
arrow. Do not grip it by the silicon section as this can easily
be ripped.
2
Attach the nose pads to the lens holder.
3
Attach the lens holder to the headset.
When the accuracy of the headset's sensor is low
If the geomagnetic sensor is not operating correctly, wave the
headset in a figure 8 shape while a smart device is connected to
calibrate the sensor.