Fitting And Removing Flange; Fitting Flange; Removing Flange; Fitting And Removing Wheel - Bosch Start Line WBE 260 Original Instructions Manual

5.

Fitting and removing flange

5.1

Fitting flange

1. Actuate pedal.
 Flange shaft blocked.
2. Screw lead screw into flange shaft.
3. Install the M14 screw.
Fig. 9: Installing the lead screw
4. Use Allen key to tighten until there is no clearance
between lead screw and flange, i.e. until tight.
"
Screw connection established
i
Install until "0" marks on flange shaft and lead screw
are aligned.
5.2

Removing flange

1. Actuate pedal.
 Flange shaft blocked.
2. Turn wrench anti-clockwise until lead screw and
flange shaft disconnect from one another.
Fig. 10: Removing flange
Fitting and removing flange | Start Line WBE 260 | 29
6.

Fitting and removing wheel

WARNING - wheel may slip!
Risk of crushing of fingers and other body
parts when attaching and removing wheel.
¶
Wear protective gloves.
¶
Wear safety shoes
¶
Do not place finger(s) between wheel and
flange shaft.
¶
Heavy wheels should always be handled
by two people.
6.1

Clamping the wheel

6.1.1

Clamping on correct side

i
The usual clamping method is with aligned sides, a
quick and easy operation suitable for normal steel
rims. This method can only be used on steel rims
where distortion is not serious.
1. Push wheel onto flange shaft with internal face onto
lead screw.
2. Fit suitable cone (small surface facing inwards).
3. Press quick-locking nut, then rotate quick locking
nut on the flange shaft.
4. Release clamping device, then rotate quick locking
nut clockwise.
Fig. 11: Install wheel on correct side
en
|
1 695 600 539 2016-07-22