GE SBSD137 Installation Instructions Manual page 3

4 LEVEL THE WASHER OR DRYER
Locate the 4 legs from the parts package and
A
install.
Stand the washer or dryer upright. Move it
B
close to its final location.
Make sure that the washer or dryer
C
is level by placing a spirit level on top. Check
side to side and front to back.
Use an open
D
ended wrench to
adjust the legs in
and out. Tighten
the lock nut
against the
bottom of
the pedestal.
must be tight.
5 REINSTALL THE DRAWER
Check to
A
be sure the
slides are
closed.
Slide the
B
drawer
Drawer
into the
divider
opening.
Align the
drawer
supports to
the slides on
each side.
Reinstall the original screws into each drawer
C
slide. Tighten both screws.
Open the drawer fully. Slide drawer divider
D
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Installation Instructions
3
6 REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the
unit.
7 FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions
to complete the installation.