Advertisement
(4) When installing the Stator [13] <13> into the Housing Ass'y [38] <38>, insert it while taking care of the
placement of the internal wires of the Stator [13] <13> as indicated in Fig. 8.
Connect the four internal wires of Stator [13] <13> with the parts indicatd in Fig. 8
Connect to the Brush Holder
[49] <48> (on the same side as the
Name Plate [39] <39>.)
Both the internal wire of the Noise
Suppressor [42] <42> and this wire
are connected to the Terminal [41]
with solderless connection and
connect it to the Switch [50] <49>
(if the Noise Suppressor [42] is not
used, connect this internal wire to
the Switch [50] <49> After
clamping the Terminal [41] <41>
with solderless connection.
(5) When connecting the Earth Terminal [40] <40> to the internal wire (the middle wire among three) of the
Noise Suppressor [42] <42>, strip the insulation sheath on the internal wire by about 6 mm and press
connect it together with the Earth Terminal [40] <40> with a clamping tool on the market.
(6) When replacing the Gear Cover Ass'y [4] <4>, lubricate the metal part with mixed oil.
Mixed oil: Mixture of Hitachi power tool grease No. 2 (Unilube No.00) and tubine oil
* Mixure ratio....1:1 (weight ratio)
Connect to the Cord [59] <58> with a Pillar
Terminal [44] <44> or clamp to the Cord [59]
<58> with a Connector [45].
Connect to the Brush Holder
[49] <48> (on the same side as the
Hitachi Label [46] <45>.)
Solderless connection
Fig. 9
* Volume....0.5 cc
−3−
Fig. 8
Advertisement
