Advertisement
CAUTION:
Captive Screws
Figure 6
Do not tighten any captive screws until each captive screw has been started to
be threaded into its hole.
12 Engage all captive screws before tightening each screw of the board com-
puter and PMC adapter(s). See Figure 6.
Rotate Ejector Handles
toward center of cards
before the cards are fully seated
Installing the Board Computer with PMC into Card Cage
13 Connect the monitor cables to the PMC graphics card and all other cables
to the SBC and card cage.
14 Plug in the power cord(s), and then turn on the power for the card cage.
15 If Autoboot is turned on, press any key when you see the following mes-
sage:
Processor is starting Autoboot process. To discontinue, press any key
within 10 seconds.
Procedure
Captive Screws
13
Advertisement
