Advertisement
2.
SPECIFICATIONS & INTRODUCTION
Composite lightweight housing reduces effects of chill on operator's hands for added comfort.
Exhaust outlet adjusts 360° keeping airflow away from operator. Heat treated alloy steel impact
components ensures suitability for the professional workshop. Supplied in storage case with five
chisels.
Model No: . . . . . . . . . . . . . SA613.V2 . . . . . . . SA614.V2
Chisel Shank Size: .401" Parker Taper .401" Parker Taper
Speed: . . . . . . . . . . . . . . . . . 4200bpm . . . . . . . . 3000bpm
Stroke: . . . . . . . . . . . . . . . . . . . 50mm . . . . . . . . . . 71mm
Air Consumption: . . . . . . . . . . . 7.4cfm . . . . . . . . . . 7.8cfm
Operating Pressure: . . . . . . . . . . 90psi . . . . . . . . . . . 90psi
Air Inlet Size: . . . . . . . . . . . . . .¼"BSP . . . . . . . . . .¼"BSP
Weight: . . . . . . . . . . . . . . . . . . . 1.36kg . . . . . . . . . . 1.56kg
Sound Power:. . . . . . . . . . . . 111dB(A) . . . . . . . . 112dB(A)
Sound Pressure:. . . . . . . . . . 100dB(A) . . . . . . . . 101dB(A)
Vibration Figure: . . . . . . . . . 13.21m/s
Uncertainty Value: . . . . . . . . . 1.8m/s
3.
PREPARING TOOL FOR USE
3.1.
Air Supply
WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the
hammer. Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage and/or personal injury.
3.1.1. Ensure hammer air valve (or trigger) is in the "off" position before connecting to the air
supply.
3.1.2. An air pressure of 90psi is required, and an air flow according to specification.
3.1.3. Drain the air tank daily. Water in the air line will damage the hammer.
3.1.4. Clean air inlet filter weekly.
3.1.5. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/4" internal diameter and fittings must
have compatible dimensions.
3.1.6. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain
that all connections are secure.
3.2.
Couplings
Vibration may cause failure if a quick change coupling is connected directly to the wrench.
To overcome this, connect a leader hose to the air hammer (Sealey ref: AH2R or AH2R/38).
A quick change coupling may then be used to connect the leader hose to the air line recoil
hose (see figs.1 & 2).
fig.1
© Jack Sealey Limited
. . . . . . . 14.04m/s
2
. . . . . . . . 1.88m/s
2
Original Language Version
2
2
SA613.V2, SA614.V2
fig.2
Issue: 1 - 04/10/13
Advertisement
