Shipping Requirements - Dell EqualLogic PS Series Hardware Owner's Manual

PS6610 Hardware Owner's Manual
Insert the New Battery
1. Attach the new battery unit to the connector, and gently wiggle and push the connector in place to
seat it. You do not need to depress the retention clip to insert the connector. When the connector is
fully seated, you should hear the retention clip click into place.
2. Place the new battery unit in the chassis by reversing the procedure from step 5 for removing the
battery.
You might need to slightly reposition the cable inside the control module to get it out of the way
Note:
and ensure easy reassembly. Make sure that the cable is not pinched between the battery cover and
the control module chassis.
3. Reinsert the screw and tighten gently.
4. Reinsert the control module and reconnect the cables.
Return or Dispose of the Old Battery
The manner in which to dispose of rechargeable batteries varies by country. Make sure that you
dispose of your old battery in a way that conforms to your country's regulations. Alternatively, you can
return the old battery back to Dell for proper disposal. See
30
3 Control Module Maintenance
Shipping Requirements on page 28.