Advertisement
NOTE: Proceed only if you are a qualified installer, otherwise; see your Authorized TORO AUDIO
Dealer or MECP Certified Installer to professionally install this amplifier. Always wear protective
eyewear when using tools.
Turn off all stereo and other electrical devices before you begin
Disconnect the negative (-) lead from your vehicle's battery
Locate all fuel lines, brake lines, oil lines, and electrical cables when planning the install
Make sure there is at least 2-inches (5 cm) around the air vents on the amplifier.
When connecting ground points, make sure all paint is carefully scrapped away from the vehicle's
chassis and contact is make with bare metal
Use a utility knife to trim away fabric from hole locations before drilling or cutting
When running power cables through sheet metal, be sure to use grommets to properly insulate the
metal edges from the wire insulation
If possible, use tubing through grommets
Due to the high-power output of the TORO AUDIO MICRO amplifiers, considerable heat may be produced
when the unit is in operation. For this reason, the amplifier should be mounted in a location which will allow
air to circulate freely. A clearance of at least 2-inches (5 cm) to all sides of the amplifier is necessary not
only for proper cooling, but also for gaining access to the inputs and other variable controls. Be sure that
the power and signal cable connections can enter and leave the amplifier in a straight line to avoid the risk
of kinked wires causing malfunction.
Fig.1 Mounting Amplifier
Advertisement
