Advertisement
‰
WARNING! DO NOT grind any materials containing asbestos.
8
DO NOT switch on the grinder whilst the wheel is in contact with the workpiece.
8
DO NOT get the grinder wet or use in damp or wet locations or areas where there is condensation.
DO NOT use grinder where there are flammable liquids, solids or gases, such as paint solvents and including waste wiping or cleaning
8
rags etc.
8
DO NOT touch the workpiece close to the ground surface as it will be very hot. Allow to cool. the workpiece may also be very sharp.
DO NOT operate the grinder when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
8
DO NOT leave the grinder operating unattended.
When not in use switch off the grinder, disconnect from the mains power supply and clean the machine and working area
8
.
2. INTRODuCTION
induction motor drive suitable for general use. Fitted with stone guards, adjustable eye shields and spark arrestors. Substantial tool rests, one
With angled cut-out assisting effective tool sharpening. Variable speed allows for better control of grinding and sharpening. Features integral
cooling tray for convenient cooling of sharpened/ground item.
3. SPECIfICATION
model no..:............................................................BG150WVS
supplied with:.............................................................2 stones
motor power:..................................................................250W
supply:............................................................................230V
Axle diameter:...............................................................13mm
no load speed range:.......................................2000-2800rpm
Weight:......................................................................... 13.8kg
model no:..............................................................BG200WVS
supplied with:.............................................................2 stones
motor power:..................................................................550W
supply:............................................................................230V
Axle diameter:............................................................... 16mm
no load speed:.................................................2000-2800rpm
Weight:......................................................................... 17.7kg
4. ASSEMBLy
fig.1
5. GRINDING WHEELS
5.1.
MANDATORy SAfETy INSTRuCTIONS. (the following instructions must be observed together with those in section 1).
▲
DANGER! Use of a damaged wheel (stone) is dangerous and may cause damage and/or personal injury.
WARNING! ensure grinder is unplugged from mains supply before attempting to change grinding wheel (stone). only persons qualified
‰
under the "Abrasive Wheels Regulations" and holding a current grinding wheel certificate are authorised to change and dress grinding
wheels (stones).
9
Grinding wheels used with this machine must be of an adequate speed rating and suitable for the material to be ground.
Ensure the maximum speed specification of the wheel is higher than that indicated on the machine data plate.
9
Check that grinding wheels are secure and that wheels are not worn or damaged, that there are no fissures or cracks. If damaged
9
replace immediately.
Ensure replacement wheel is not damaged in any way such as cracks, deformations or splinters etc. Also check the mounting flanges
9
for deformation, burrs or chips. Damaged flanges must not be used as they may produce high stresses in the wheel causing it to
break. DO NOT over tighten a wheel. Never tamper with a wheel in order to adapt it to a different size shaft.
© Jack sealey limited
fig.2
Original Language Version
BG150WVS,BG200WVS | Issue 2 28/10/16
Advertisement
