Huawei iBattery 3.0 Quick Manual page 11

4.2 Logging In to the ECC800 WebUI and Setting Parameters
1. Use a straight-through cable to connect the PC to the
FE port on the ECC800.
2. Enter https://ECC800 IP address in the address box of
Internet Explorer to log in to the ECC800 WebUI
homepage.
3. Choose Monitoring > Power Distribution > iBOXn >
Running Parameters, set battery parameters by
referring to the following table.
Parameters
iBOX single battery
qty.
Batt installation
time
Battery string
capacity
Current source
BCB tripping upon
battery abnormal
Battery string No.
5
Cable Connections and Commissioning (NetEco Scenario)
5.1 Connecting Cables
Scenario 1: If the LAN switch provides the POE function, directly connect the iBOX to the LAN
switch through the POE port. An iBOX adapter does not need to be installed.
Scenario 2: If the LAN switch does not provide the POE function, the iBOX obtains power from the
adapter through the POE port and communicates with the LAN switch through the DATA port on
the adapter.
The communications cable, with an RJ45 connector, delivered with the BCB box is used to conn
ect the new BIB board, and the cable without an RJ45 connector is used to connect the old BIB
board.
Description
Total number of batteries monitored by the
iBOX.
Actual time at which batteries are installed.
Capacity of a single battery.
Select a Hall effect sensor (xxx A).
If the BCB box is configured, set BCB
tripping upon battery abnormal to Enable.
The serial number of each battery string. Set
this parameter based on the planned codes
for iBOXs and battery strings. The Battery
string No. are unique for a same UPS.
Default ECC800 settings:
•
IP address: 192.168.0.10
•
Subnet mask: 255.255.255.0
•
Gateway: 192.168.0.1
•
User Name: admin
•
Password: Changeme
11
Remarks
Set according to the battery
parameters planned by the
customer.
N/A
Obtain the battery capacity
from the battery label.
The actual specifications of
the Hall effect sensor prevail.
N/A
Set according to the
customer plan.