Advertisement
Display radios will show
radio) and
4. Release both side buttons of source radio.
The electronic transfer begins and will take
less than one minute. When cloning is
completed, the source radio produces a
"clone-exit" tone and displays
radios reset themselves and turn off their
green LEDs.
5. Turn off source and target radio; then dis-
connect cloning cable from each radio.
6. Turn on source and target radio for normal
operation.
ERROR CODES (Display Radios Only):
•
— The model numbers or the code
ERR 01
plug versions are not the same for both
radios. Cloning cannot be performed.
•
ERR 02
radios was not established or was dis-
rupted during the cloning procedure. If this
occurs, check the cloning cable and all
connections. Repeat the cloning proce-
dure.
PROGRAM
— Communication between the two
CLONE
(target radio).
2
(source
. Both
DONE
Advertisement
