Configuration In Network Mode; Creating A Project In Network View And Two-Way Programming - Siemens SIMATIC HMI KTP400 Manual

3 Mode of Operation
3.2

Configuration in network mode

From LOGO! Soft Comfort V8 onwards, you are now able to interconnect several
LOGO! base modules with each other and with other devices (WinCC and S7-
CPUs) in the new network view.
Communication between the devices will be configured automatically.
In addition, it is possible to display three programs at once and to drag&drop
signals from one program to the other.
3.2.1

Creating a project in network view and two-way programming

Adding a device in network view
Table 3-1
No. Action/response
1. Start LOGO!Soft Comfort V8.
Click on "Network project" tab to
2.
open the network project view.
Click on "Add new device".
3.
The subsequent window enables
you to add devices you want to
use to the network.
4. The network view gives you an
overview of the devices used in
your network.
House Control and Weather Sensors - LOGO! Set 11
Entry ID: 68585346, V2.1, 09/2018
LOGO!Soft Comfort V8
11