Table of Contents
Advertisement
Important Safety Warnings
•
Installation should be made by a qualified service person and should
conform to all local codes.
•
DO NOT bundle UTP signals in the same conduit as high-voltage wiring.
•
To reduce the risk of fire or electrical shock, do not expose these products to
rain, moisture, dripping or splashing.
•
No objects filled with liquids, such as vases, shall be placed on GE equipment.
•
DO NOT block ventilation openings to let sufficient airflow to the UTP devices.
•
The Main fuse for models with built-in AC power supply is 5 A at 110 VAC or
at 3 A 220 VAC. Each camera power fuse is 2 A and can be accessed by
removing the front panel. Fuses may be replaced by a qualified service
person only when the unit is off and AC power cord is unplugged.
•
Use only the power cord and plug supplied with the unit for connecting to AC
outlets.
•
Only unplugging the power cord is considered as a main power disconnect.
•
DO NOT connect multiple outputs together.
•
Make sure that the mains Voltage input is set to the proper local voltage.
Wiring Technical Notes
These technical notes should all be considered prior to installing these devices.
•
Use point to point unshielded twisted pair wire 24-16 AWG (0, 5-1, 3 mm)
stranded or solid, Category 2 or better.
•
The video signal may coexist in the same wire bundle as other video,
telephone, data, control signals, or low-voltage power. You can run GE video
signals in or near electromagnetic fields (in accordance with National
Electrical Code, local or other local safety requirements).
•
DO NOT USE SHIELDED TWISTED PAIR WIRE. Multi-pair (8 pair or more) wires
with an overall shield are fine.
•
DO NOT USE UN-TWISTED WIRE.
•
DO NOT place a transmit and a receive signal in the same wire bundle. It
may cause interference.
P/N 1069680 • REV 1.0 • ISS 14APR10
3 of 12
Advertisement
Table of Contents
