Recording Cd/Video-Cd Sources - Yamaha GX-90VCD Owner's Manual

RECORDING CD/VIDEO-CD SOURCES

6 1
MINI COMPONENT SYSTEM
GX–90VCD
VIDEO CD
Version 2.0 / Playback Control
1
2
3
PROGRAM
MUSIC
INPUT
ECHO ECHO
USER MEMORY
TAPE 1/2
REC/PAUSE
MODE
DOLBY NR
POWER
PHONES
TIMER REC
AUTO/MAN'L
TIMER
HOUR
1
PLAYBACK
EJECT
3 4
CD
1 2
1 2
6 7
6 7
A B
TIME PROG TAPE
MODE INDEX REPEAT
DISC SKIP PREV NEXT
5 REC/PAUSE TAPE 1/2 PLAY
CENTER/REAR
TEST FLAT
/DELAY
ECHO/KEY
MUSIC
LEVEL
POWER
SLEEP
VOLUME
6
DISC CHANGE
OPEN/CLOSE
VOLUME
CD
INPUT
NORMAL
Active Servo
HIGH
Technology
MIC MIXING
DUBBING
MEMORY
TIME ADJ
MIN
2
REC/PLAYBACK
EJECT
5 2
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
EDIT I0
OPEN/CLOSE TUNER
RETURN SELECT
6
STOP PLAY
TAPE
PROGRAM USER
INPUT
1
General information
•
When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
•
The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
•
Adjusting the VOLUME control has no effect on the
recorded sound.
If, however, the built-in graphic equalizer and/or sound
field processor is used, its effect is recorded along with
the source.
* Music with an equalizer effect is suitable for listening to
inside a car etc.
•
For the tape deck, the deck which can be used for
recording is deck 2 only. When recording, be sure to load
a tape into the deck 2 cassette compartment.
•
Recording cannot be done if the tape deck is selected as
the playback source.
Synchronized recording
1
Press the CD input selector button and load the disc to be
recorded.
2
Load a tape into the deck 2 cassette compartment.
* Wind past the beginning part of the tape on which
recording cannot be performed.
3
When recording with the Dolby NR system, press the
DOLBY NR button so that "
If not, turn it off.
* For details, refer to the "Dolby B Type Noise
Reduction" on page 31.
4
If desired, switch the reverse mode by pressing the
reverse MODE selector button.
When the tape is set so that side A faces you, recording will
be done as follows automatically according to the selected
reverse mode.
Side A only
Side B only
5
Press the REC/PAUSE button.
* "REC" lights up on the display.
6
Start disc playback by pressing the corresponding DISC
selector button, or by pressing the play/pause
button if the disc is already selected.
* Before disc playback begins, recording automatically
begins on the side of the tape now selected.
E-35
B" lights up on the display.
Side A Side B
Side B only
/