Electrolux GA60LIWE User Manual page 45

5. Set and start a programme suitable
for the type of load and the degree of
soil.
9.1 Using the detergent
A B
C
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press repeatedly until the
indicator of the desired programme is
on.
The display shows the programme
duration.
4. Set applicable options if desired.
5. Press to start the programme.
• The indicator of the running phase
is on.
• The programme duration counts
down in minutes.
Starting a programme with
delay start
1. Set a programme.
2. Press repeatedly until the display
shows the desired delay time (from 1
to 24 hours).
The indicator is on.
3. Press to begin the countdown.
The remaining time counts down in
hours. The final hour is displayed in
minutes.
When the countdown is complete, the
programme starts and the indicator of the
running phase is on. The indicator
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Cancelling the delay start while
the countdown operates
When you cancel the delay start, you
have to set a programme and options
again.
Press and hold simultaneously
until the appliance is in programme
selection mode.
ENGLISH 45
is
and