Yamaha SU700 Owner's Manual page 218

IMPORTANT
Note that you cannot connect a given track to more than one insertion effect. (See il-
lustration, page 191.) If you try to switch on the connection for a track that is already
connected to an insertion effect on one of the other two effect blocks, the screen will
display the REPLACE? query. Press [CANCEL] to leave the track's connections un-
changed, or press [OK] to switch on connection to the selected block and switch off its
connection to the other block.
4.
Press
At each page, turn the dial as necessary to set the value. (If necessary, you can move
back to a previous page by pressing
Note that all settings become effective immediately, and cannot be canceled with the
[CANCEL] button. For information about parameters, refer to the "Parameters" section
at the bottom of this procedure.
EXAMPLE 1: First parameter-setting page for the HALL effect (system effect).
Indicates that preceding page exists.
Brackets indicate mute settings,
and cannot be changed from this
screen.
EXAMPLE 2: First parameter-setup page for the TREMOLO effect (insertion effect).
Brackets indicate that track is connected to the effect block.
(You can change connection settings using bank selectors and pads.)
5.
When you have finished making settings, press [OK] or [CANCEL] to return to the
main screen.
218
to advance to each of the parameter-setting pages.
Parameter name
Parameter name
Chapter 9 Editing Functions
). Each page sets the value for a single parameter.
Parameter value
Indicates that next page exists.
Effect level settings for each track. (You can adjust
levels while at this screen, or at any time during
recording, standby, and playback.
Parameter value