Level Meter Display; L/R Select; Input/Output Level Display - Yamaha WK83840 Owner's Manual

Level Meter Display

4 L/R Select

Indicates when the spectrum display is for the left or right
channel. The same spectrum display will be shown for the
L and R channels of all monitor points other than user-
defined points specified via the DME Designer
application.
To switch between the L and R displays move the cursor to
the CHANNEL L/R setting and press the [ENTER] key
to alternately select L or R.
NOT E
The fall rate of the meters can be set up via the Utility display
"Disp" page.
42
DME64N/DME24N Owner's Manual
Level Meter Display
Individually displays the input/output level for each
channel.
N OTE
Level display is not available on the ICP1 control panel.
1.
Make sure that the Main display is showing.
If the Main display is not showing, press the [CANCEL]
to return.
2.
Press the [UTILITY] key.
The level meter display will appear.
1
2
1 Level Display Slot
Select from [SLOT1] ~ [SLOT4], [AD/DA],
[CASCADE IN] or [CASCADE OUT].
N OTE
[SLOT2] ~ [SLOT4] and [CASCADE IN], [CASCADE OUT]
are only available on the DME64N, while [AD/DA] is only
available on the DME24N.
2 Channel Number
A maximum of 32 [CASCADE IN]/[CASCADE OUT]
channels can be displayed, while for other channels a
maximum of 16 can be displayed.

3 Input/Output Level Display

Shows the levels at the individual inputs and outputs.
4 Peak Hold
When the peak hold function is set to ON, peak levels are
held indefinitely.
Peak levels are cleared after one second when peak hold is
set to OFF.
To turn the peak hold function ON or OFF, move the
cursor to the PEAK HOLD ON/OFF setting and press the
[ENTER] key to alternately turn it ON or OFF.
4
3