Midi - Rcvflt (Receiving Filter) - Yamaha A3000 Owner's Manual

MIDI - RcvFlt (Receiving Filter)

Sets up filtering of MIDI data.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
This page selects the types of MIDI messages accepted by the A3000. The A3000 accepts
messages of a given type only if the corresponding parameter is set to enable. If the
setting is disable, the A3000 filters out (ignores) messages of this type.
Note that the settings that you make here remain effective when you are recording a
sequence. If you disable control-change messages, for example, then the sequence will
not register any control-change messages that are received during recording.
Knob 1 Change Page
• Turn the knob to change to a different page within the MIDI function. Available pages
• Push the knob to move to the Program/Sample Selection screen. ( 95)
CtrlCng
Knob 2
Set this to enable if you want to allow control-change data to pass to the tone generator.
Set to disable if you want the A3000 to ignore (filter out) all control-change data.
AftrTch
Knob 3
Set this to enable if you want to allow aftertouch data to pass to the tone generator. Set
to disable if you want the A3000 to ignore (filter out) all aftertouch data.
PtchBnd
Knob 4
Set this to enable if you want to allow pitchbend data to pass to the tone generator. Set
to disable if you want the A3000 to ignore (filter out) all pitchbend data.
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
are: Receive, Adjust, RcvFlt (this page), and Bulk.
= enable, disable
= enable, disable
= enable, disable
MIDI Function
Turn Knob 1 to select RcvFlt.
Knob 3 Knob 4
- -
Select P/S
Chapter 8
Knob 5
-
-
UTILITY Mode
309