Using The Hdmi Changeover Switch - Silvercrest SHU 3.1 B2 Operating Instructions Manual

Using the HDMI changeover switch

♦ Switch your output device (e.g. television or beamer) on and
activate the HDMI input to which the HDMI changeover switch
is connected. To do this, follow the operating instructions for
the output device.
♦ Switch on the source device that you wish to use. The HDMI
changeover switch automatically changes over to the relevant
channel. The channel that has been selected (1, 2 or 3) is
indicated by the relevant channel LED
♦ Press SELECT
the SELECT button switches the channel to the next switched-on
source device in descending order.
NOTE
► If a source device is switched off , the HDMI changeover
switch automatically switches to the next source device that
is switched on in descending order
► Some source devices also output a signal on the HDMI output
when they are in standby. It is therefore possible that the auto-
matic changeover will not always take place. In this case a
manual changeover is required.
SHU 3.1 B2
3
to select a channel manually. Each press of
2 .
3 2 1
.
GB
IE
9