Connections; Connecting The Unit; Connecting A/V Components - Yamaha DPX-1000 Owner's Manual

Connecting the unit

• Make sure that the power of this unit and all other components is turned off before making any connections.
• Some components have different connection methods and connector names.
Refer to the operating instructions for each component that you wish to connect.
• Plug the unit in correctly to prevent it from creating noise or other problems.
I Connecting A/V components
As shown in the illustration below, there are 6 types of connections provided on this unit for connection to A/V components.
Follow the instructions on the figure below to connect A/V video outputs from other components to this unit using the correct cables and
adapters.
Input
VIDEO
S-VIDEO
INPUT A
INPUT B
D4 VIDEO
DVI
D connector cable
DVI cable (digital)
D1—4 output DVI output
connectors connector
N Note N
• Make sure to match the Y/P
nent jacks. Also, refer to the operation instructions for the A/V component. HD/SYNC and VD need to be connected for RGB video
signals in some cases.
Signal type
Composite video
S video
Component video/RGB video
Component video/RGB video
Component video
Component video/RGB video (digital)
DVI
INPUT B
RGB/YP B P R /YC B C R D4 VIDEO
D-sub monitor
cable
D-sub Pin jacks
Component/RGB video output connectors
Image output from A/ V components
/P or Y/C /C of the A/V component and this unit when connecting a component to INPUT A compo-
B R B R
Connector type
Pin jack
Mini DIN connector
BNC connector x 3—5
D-sub 15 pin
D connector
DVI connector
OUT IN
REMOTE
INPUT A
G/Y B/P B /C B R/P R /C R HD/SYNC VD
BNC cable for component
connection
Pin/BNC
adapters
Pin cable
G/Y B/P B /C B R/P R /C R
BNC jacks
RS-232C TRIGGER OUT
S-VIDEO VIDEO
Video pin cable
S video cable
S video output Video output
jack jack
9
E-