Yamaha CinemaStation TSS-15 Owner's Manual page 20

Problem
The source is Dolby Digital
and the Auto listening
mode is selected, but the
center and surround
speakers output no sound.
The source is Dolby Digital
or DTS, but the Dolby
Digital or DTS indicator
doesn't light up.
A humming noise can be
heard.
Noise can be heard.
The sound is distorted.
The TSS-15 doesn't work
properly.
Noise can be heard when
the TSS-15 amplifier is
situated close to another
electronic device.
The remote control doesn't
work.
18
Possible cause
The Dolby Digital signal contains
only two channels.
The DVD player is not set correctly.
An audio cable is not connected
properly.
The level of the input signal is too
low.
An audio cable is not connected
properly.
The level of the input signal is too
high.
The internal microprocessor has
locked up due to external electrical
shock (lightning or excessive static
electricity) or a drop in the power
supply voltage.
The electronic device's high-
frequency circuits are causing
interference on the TSS-15 amplifier.
The battery is depleted.
You're too far away from the TSS-15.
Direct sunlight or lighting (inverter-
type fluorescent light, etc) is shining
on the TSS-15's remote control
sensor.
Remedy
If the DVD being played has a 5.1-channel
soundtrack, select it on the DVD player.
If not, you can still use all speakers by
selecting the Dolby Pro Logic II Movie or
Music listening mode.
Make sure that the DVD player is
configured to output Dolby Digital and
DTS (bitstream) signals from its digital
output. Refer to its manual for details.
Check all audio connections and correct as
necessary.
Increase the output level on the source
component.
Check all audio connections and correct as
necessary.
Reduce the output level on the source
component.
Disconnect the power cable from the wall
outlet, wait for about 30 seconds, then plug
it back in again.
Move the TSS-15 amplifier and electronic
device away from each other.
Replace with a new CR2025 battery.
1. Using a small screwdriver, carefully
slide out the battery holder.
2. Remove the expired battery, and place
the new battery onto the battery holder
with the + side facing up.
3. Slide the battery holder into the remote
control, and push it so that it clicks shut.
+ side up
2
3
1
• Do not attempt to recharge the old battery.
• Dispose of the old battery in accordance
with local regulations.
The remote control has a maximum
working range of 6 meters (20 feet), and a
working angle of 30 degrees.
Reposition the TSS-15 amplifier.
Refer to
page
15
—
10
—
10
—
—
—
—
5
—