Setting The Speaker Impedance - Yamaha RX-N600 Owner's Manual

Setting the speaker impedance

CAUTION
If you are to use 6 ohm speakers, set "SP IMP." to
"6 MIN" as follows BEFORE using this unit. 4
ohm speakers can be also used as the front
speakers.
2,5
MASTER
PRESET/TUNING FM/AM A/B/C/D/E
EDIT
NEXT
SEARCH MODE CATEGORY
ON OFF
PROGRAM
MAIN ZONE
PHONES SPEAKERS
A B STRAIGHT TONE CONTROL
ON/OFF
EFFECT
SILENT CINEMA
2,4 3
1
Make sure this unit is turned off.
See page 28 for details about turning on or off this
unit.
2
Press and hold STRAIGHT (EFFECT) on the
front panel and then press MASTER ON/OFF
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
down
STRAIGHT
EFFECT
3
Rotate the PROGRAM selector on the front
panel to select "SP IMP.".
The following display appears in the front panel
display.
PROGRAM
S P I M P . - 8 M I N
(U.S.A. model)
VOLUME
ZONE 2 ZONE
ON/OFF CONTROL
l PRESET/TUNING/CH h MEMORY TUNING MODE
MAN'L/AUTO FM AUTO/MAN'L
LEVEL
DISPLAY
INPUT
INPUT MODE MULTI CH
INPUT
VIDEO AUX USB
VIDEO L AUDIO R
MASTER
ON OFF
4
Press STRAIGHT (EFFECT) on the front
panel repeatedly to select "6 MIN".
The following display appears in the front panel
display.
STRAIGHT
S P I M P . - 6 M I N
5
Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and turn off this unit.
MASTER
ON
Note
The setting you made is reflected next time you turn on this unit.
CONNECTIONS
EFFECT
OFF
27
En