■ Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
10 mm (0.4 in)
2
Loosen the knob.
Red: positive (+)
Black: negative (–)
3
Insert one bare wire into the hole on the side
of each terminal.
Red: positive (+)
Black: negative (–)
4
Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (–)
■ Connecting to the PRESENCE speaker
terminals
Connect presence speakers to these terminals.
1
Open the tab.
2
Insert one bare wire into the hole on the side
of each terminal.
3
Close the tab to secure the wire.
CONNECTIONS
15