Yamaha R-V701 Owner's Manual page 12

7
Select the center channel output mode according to your
speaker configuration.
(Refer to "SPEAKER CONFIGURATION" on page 6.)
CENTER
MODE
On the feature of each mode, refer to the "Note" shown
below.
Note
In step 7, when you select the center channel output mode,
note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use a center speaker
that is smaller than the front speakers. In this
mode, the bass tone will be output from the front
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the front speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and right front speakers.
R-V501 only
*
When the DOLBY 3 STEREO program is used, the
PHANTOM mode cannot be selected.
12
9
8
7
NORMAL
WIDE
PHANTOM
R-V701
REC/PAUSE STOP
DECK A/B VCR MON
CENTER
MODE PRO LOGIC ENHANCED CNCT VIDEO
SUR.
+
MONO MOVIE ROCK HALL
DELAY EFFECT
+
—
TIME ON/OFF VOLUME 9
—
8
TEST
9
Turn up the volume.
You will hear a test tone (like pink noise) from the left front
speaker, then the center speaker, then the right front
speaker, and then the rear speakers, for about two
seconds each. The display changes as shown below.
R-V701
Front (L) Center
Rear Front (R)
(L and R)
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
R-V501
REC/PAUSE STOP
DECK A/B VCR MON
CENTER
MODE PRO LOGIC 3 STEREO
7
SUR.
+
HALL ROCK
DELAY EFFECT
+
—
TIME ON/OFF VOLUME
—
TEST
Flashes continuously.
R-V501
(L and R)
9