Impedance Selector Switch - Yamaha RX-V3200 Owner's Manual

I IMPEDANCE SELECTOR switch
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise this unit
may be damaged.
If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR
switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the
standby mode.
Select the left and right position according to the impedance of the speakers in your system. Be sure to move this switch
only when this unit is in the standby mode.
IMPEDANCE
SELECTOR
switch
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR
REAR CENTER :
CENTER
MAIN A OR B :
A B :
REAR
REAR CENTER :
CENTER
MAIN A OR B :
AC OUTLETS
SWITCHED
100W MAX. TOTAL
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR :
4ΩMIN. /SPEAKER
REAR CENTER : 4ΩMIN. /SPEAKER
CENTER : 4ΩMIN. /SPEAKER
MAIN A OR B : 4ΩMIN. /SPEAKER
A B : + 8ΩMIN. /SPEAKER
REAR : 8ΩMIN. /SPEAKER
REAR CENTER : 8ΩMIN. /SPEAKER
CENTER : 8ΩMIN. /SPEAKER
MAIN A OR B : 8ΩMIN. /SPEAKER
(U.S.A. model)
Switch
position
: 4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
: 4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
+
8ΩMIN. /SPEAKER
: 8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
Upper
:
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
Lower
Speaker
If you use one set of main speakers, the impedance of
each speaker must be 4 Ω or higher.
Main
If you use two sets of main speakers, the impedance of
each speaker must be 8 Ω or higher.
The impedance must be 4 Ω or higher.
Center
The impedance must be 4 Ω or higher.
Rear
Center
The impedance of each speaker must be 4 Ω or higher.
Rear
Main If you use one set of main speakers, the impedance of
each speaker must be 8 Ω or higher.
The impedance must be 8 Ω or higher.
Center
The impedance must be 8 Ω or higher.
Rear
Center
The impedance of each speaker must be 8 Ω or higher.
Rear
SPEAKER SETUP
Impedance level
13