Clearing Function Sets - Yamaha RX-V4600 Owner's Manual

REMOTE CONTROL FEATURES
4
Press the buttons for the functions you want
to include in the macro operation in
sequence.
You can set up to 10 steps (10 functions). After you
have set 10 steps, "FULL" appears and the remote
control automatically exits the macro mode.
SYSTEM
POWER POWER STANDBY POWER
TV AV
2
A B AUDIO SELECT SLEEP
3
PHONO TUNER CD MULTI CH IN
V-AUX CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
Flashes alternately so you can
set the next step
Note
To change the selected source component, press
SELECT k / n
. Pressing the input selector buttons will
program a macro step, whereas
the selected component and corresponding component control
area.
5
Press MACRO again when the operation
sequence you want to program is complete.
Note
"ERROR" appears in the display window if you press a
button not indicated in the respective step, or if you press
more than one button simultaneously.
Memory back-up
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. If the memory is cleared, insert new batteries,
set up the remote control code(s) and program any
acquired functions that may have been cleared.
78
MCR 2: AV POWER
MCR 3: AUDIO SELECT
MCR 1: DVD
1
Indicates the
number of macro
steps entered
SELECT k / n
only changes

Clearing function sets

You can clear all changes made in each function set, such
as learned functions, macros, renamed source names and
setup remote control codes.
1
Set AMP/SOURCE/TV to AMP or SOURCE.
AMP
SOURCE
TV
2
Press CLEAR by using a ballpoint pen or
similar object.
"CLEAR" appears in the display window.
CLEAR
Note
If you do not complete each of the following steps within 30
seconds, the clearing mode will be automatically canceled.
In this case, press CLEAR again.
3
Press k / n to select the clear mode.
L;CD (L: name of a component)
Clears all learned functions in the respective
component control area. Press an input selector
button to select the component.
L;AMP Clears all learned functions for this unit's control
area.
L;ALL Clears all learned functions.
M;ALL Clears all programmed macros
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the remote
to the factory settings.
4
Press and hold CLEAR again for about 3
seconds.
"WAIT" appears in the display window. If clearing
was successful, "C;OK" appears in the display
window.
CLEAR
y
Once you have cleared a learned function for a button, the
button reverts to the factory setting (or to the manufacturer
setting, if you have set remote control codes).
Note
"L;ALL" and "FCTRY" may take about 30 seconds to
complete.