Control Panel On Voltage Converter / Bluetooth® Remote Control Module; Remote Control Module; Installation & Connection; Preparation - AEG SW 600 W Manual

Control panel on voltage converter / Bluetooth®

remote control module

19
ON / OFF
20
MODE
21
22
Remote control module
22
19
No. Description
230 V output (AC)
1
Data cable port (RC2) when using the Bluetooth®
2
remote control module
uSB port
3
Mounting rail
4
230 V output for extension cable (AC)
5
230 V input (AC) for mains priority circuit
6
Fuse
7
Data cable port
8
(remote control module)
Red connection (+) with terminal screw
9
10 Black connection (-) with terminal screw
11 Earth connection
12 Fan cover
13 230 V extension cable
23 24 25
23
21
INSTALLATION &
CONNECTION

Preparation

•
•
•
No. Description
230 V low heat device connecting cable for mains
14
priority circuit
Connecting cable for remote control module
15
Earth cable with clip
16
Terminal connection cable (-) with rings (black)
17
Terminal connection cable (+) with rings (red)
18
Power button
19
MODE button
20
„Sleep Mode" button (power save mode)
21
green power LED
22
green „Sleep Mode" LED (power save mode)
23
orange mains priority circuit LED
24
red fault LED
25
Before connecting the voltage converter you must
check the terminals on the vehicle's battery. The
voltage converter must not be used with vehicles
where the positive terminal "+" is connected to a
metal part of the vehicle.
Only use the included cables with rings to con-
nect to a 12 V direct current power supply (e.g.
automotive battery). If the included cables are too
short, you may also use insulated copper cables
from a speciality retailer.
use the shortest possible cable. The suitable
cable diameter must be selected based on the
length of the cable between the voltage converter
and power source. If you are unsure about some-
thing, please contact your speciality retailer.
English 33