Kenwood CD Series Instruction Manual page 5

SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD
audio component system lets you take advantage of convenient
system control operations.
There are tw o KENWOOD system control modes. M ake connec-
tions according to the groups of terminal symbols show n below .
lets you combine F , f, and ƒ terminals
[XS 8] M ode :
[SL16] M ode : for
This unit is compatible w ith both [XS8] and [SL16] modes.
Select the mode according to the connected components.
÷ Do this operation after completing all connections.
(Ensure that the unit is set to STANDBY mode.)
Notes Notes
1. If your amplifier or receiver does not have a system control terminal, do not
connect any system control cords to the system control terminals on the other
components.
2. Do not connect system control cords to any components other than those
specified by KENWOOD. It may cause a malfunction and damage your
equipment.
3. Be sure the system control plugs are inserted all the w ay in to the system
control terminals.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit w ith the system remote control unit supplied w ith the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically sw itches the input selector on the amplifier or receiver w hen you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording w ith the start of playback w hen recording from a CD. Also, the simple CCRS operation enables great recordings from
CDs.
See the operating instructions supplied w ith your cassette deck for details.
Adjusting the output levels of the output jacks
and headphone output (Except for CD-203/DPF-
R3010)
The OUTPUT level (UP/ DOWN) keys of the remote control
unit can adjust the output levels from the LINE/ OUT and
PHONES jacks of the unit.
REM OTE CON TROL UN IT
RC-P0 6 0 1
÷ It is not favorable for the sound quality to decrease the output level from
this unit too much. Use these keys for coordination w ith other line
levels.
÷ Adjusting the headphone output level also changes the LINE/OUT
level. Do not adjust the output level from this unit particularly during
recording.
÷ Please note that the sound output is at the maximum level w hen the
pow er is turned on.
Downloaded from: http://www.usersmanualguide.com/
terminals only
j
SL1 6 XS 8
OUTPUT
DOW N UP
4
To use the headphone (Except for CD-203/DPF-
R3010)
Connect a stereo headphone to the PHONES jack of the CD
player. Adjust the sound volume using the remote control
unit.
CD-206/ DPF-R6010
O T U
CD-204/ DPF-R4010
System connections
CD-2 0 6 / 2 0 4 / 2 0 3 / DPF-R6 0 1 0 / R4 0 1 0 / R3 0 1 0 (En)
Amplifier or receiver
SYSTEM
CON TROL
SYSTEM
CON TROL
SYSTEM
CON TROL
Output level
P T U - 1 2 B d
1 2 3 4 5
6 7 8 9 1 0
_ 1 2 d b
Output level
5
This unit
Cassette deck