Connection Of Speakers - Kenwood R-SE7 Instruction Manual

12

3. Connection of speakers

Connect the speakers as show n in the figure.
Do not plug the pow er cord into a w all AC outlet until the connection has been completed.
1 Cord preparation.
2 Loosen.
3 Insert.
4 Secure.
¶ Never short-circuit the + and – speaker cords.
The protection circuit w ill operate and no sound w ill
be put out.
¶ If the left and right speaker connections or the + and
– polarity are inverted, the sound w ill be unnatural
w ith unclear localization of musical instruments, etc.
Be sure to connect them w ithout mistake.
Downloaded from: http://www.usersmanualguide.com/
Speaker (right)
(6-16Ω)
· ª
SPEAKERS
( 6 - 16 )
R-SE7
SPEAKERS
( 6 - 16 )
R
Super w oofer (SW-500) (optional)
Extremely low frequency sound is played back pow erfully.
This can be used w ith any type of playback.
Speaker (left)
(6-16Ω)
ª
R L
SUPER
FM 75
WOOFER
AM SYSTEM
PRE OUT
ANTENNA CONTROL
GND
L
L
R
IN IN REC PLAY REC PLAY
CD AUX TAPE M D
SUPER
WOOFER
PRE OUT
System connection
R-SE7 / DP-SE7 / X-SE7 (En)
·