Husqvarna 122C Workshop Manual page 8

1
6
Starter
Tension the return spring.
Check the spring tension.
Fit the starter on the engine body.
Mount the starter on the engine body.
502 71 27-02
Replacing the drive dogs
Dismantle the drive body.
521 54 83-01
NOTE!
Position the piston stop so it is clamped between the piston crown and the
combustion chamber. Not so it sticks out into the exhaust port.
Remove the circlip and replace any damaged
drive dogs or springs, if necessary.
Tension the return spring.
Pull the starter cord out completely and slow
the starter pulley with your thumb.
Lift the cord into the notch on the starter
pulley.
Now turn the starter pulley anticlockwise,
4 turns.
Check the spring tension. With the starter
cord fully extended it should still be possible
to turn the starter pulley further, at least a
half turn.
Fit the starter on the engine body and check
that the drive dog engages.
Fit the starter on the engine body and check
that the drive dogs engage.
NOTE!
Screw in place the 3 screws with
the metric threads as shown in the
illustration.
Replacing the drive dogs
Fit the piston stop, no. 521 54 83-01 in the
spark plug hole and loosen the drive disc
cup. (The nut is soldered onto the disc drive.)
Remove the circlip holdings the drive dog.
Lift out the drive dog and spring for repla-
cement.
Assemble in the reverse order as set out
for dismantling.