Huawei 5G CPE Max Quick Start Manual page 6

Power adapter
1 Power button
4 WAN & POWER port
Pressing the Reset button on the power adapter does not restore the CPE to its factory settings. To do
so, press the Reset button on the bottom of the CPE instead.
Outdoor Installation and Configuration
Perform the following steps to install and configure the CPE:
Step No. Operation
1 Insert the card.
2 Insert the CAT.5e Ethernet cable into the Power/LAN port, and secure the waterproof PG
connector.
3 Power on the power adapter.
4 Pick an installation location with good signal strength.
5 Install the CPE outdoors.
6 Run the CAT.5e Ethernet cable through a window or wall.
7 Plug it into the indoor router.
8 Connect your devices to the indoor router via Wi-Fi or a network cable to access the Internet.
1
2
WAN&
LAN
POWER
3
Reset
2 Power indicator
5 Charging port
4
5
4
3 LAN port