Setup; Mount Finger Deck - Toro 07081 Operator's Manual

Setup

Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description
Operator's Manual
Parts Catalog
Registration card

Mount Finger Deck

1. Roll the deck under the Versa Vac. Make sure hydraulic
motor is on the left side.
2. Slide the tow arms onto the frame pins. Secure each tow
arm to frame pin with a washer and hair pin cotter
(Fig. 1).
1
Figure 1
1. Tow arm
3. Connect each lift chain to a deck bracket with a clevis
pin and hair pin cotter (Fig. 2).
1
Figure 2
1. Lift chain
Qty. Use
1 Read before operating the machine.
1
1 Fill out and return to Toro.
4. Install canvas ring around the lip on the Versa Vac and
deck openings (Fig. 3).
1. Canvas ring
5. Connect hydraulic motor hose quick couplers to the
Versa Vac couplers as shown in figures 4.
Note: Verify rotation of fingers. Fingers should rotate
clockwise (as viewed from motor end of deck).
1
1. Motor hose –front
2. Motor hose –center
Note: If deck is not level when it is raised off the ground,
reposition lift chain in another mounting hole in bracket.
6
Figure 3
3
2
Figure 4
3. Motor hose –rear
1