Sealey VSE4787 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instructions protection
1. safety
WArninG! ensure Health and safety, local authority and general workshop practice regulations are adhered to when using tools.
‰
Do not use tools if damaged.
8
Do not use tool for purposes other than for which it is designed.
8
Do not use tool when you are tired or under the influence of alcohol, drugs or intoxicating medicines.
8
maintain tools in good and clean condition for best and safest performance.
9
ensure that a vehicle which has been jacked up is adequately supported with axle stands and that the wheels are chocked, refer to the
9
vehicle manufacturer's service instructions, or a proprietary manual.
ensure that work area has adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
Wear approved eye protection. A full range of personal safety equipment is available from your sealey dealer.
9
Wear suitable clothing to avoid snagging. do not wear jewellery and tie back long hair.
9
Do not use air tools to operate the force screw.
8
When not in use, store tool in a safe, dry childproof area.
9
important: the force screw must be kept well lubricated.
9
Warning! failure to comply with these instructions may result in damage to the tool or vehicle and/or personal injury.
‰
Warning! the warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations
‰
that may occur. it must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
important: this manual is provided as a guide only, refer to the vehicle manufacturer's service instructions, or a proprietary
9
manual, to establish the current procedure and data.
2. introDuction
suitable for the removal/installation of the rear trailing arm mounting bushes on Vauxhall/opel vehicles. can be used in situ without
removing the arm from the vehicle. features a slotted adaptor for visual reference while in operation. supplied in carry case.
3. specification
model no: ................................................................ Vse4787
Applications: ........................... Vauxhall/opel; Astra H(04-15),
.............................................Zafira B(05-15), Meriva B(10on)
item description
A
B
c
d
e
f
4. operation
4.1. note! pictures taken with the wish-bone removed from it's housing for clarity. refer to the vehicle manufacturer's service instructions,
or a proprietary manual to carry this out.
4.2. note! this tool will insert the bush to the correct depth, but before installing the new bush, refer to the vehicle
manufacturer's service instructions, or a proprietary manual, to establish the correct horizontal alignment/positioning of the bush.
important: this tool is designed to aid removal of the bush. We suggest that the area around the bush is thoroughly cleaned.
the threads of the tool should also be thoroughly lubricated in use.
Do not use an impact socket with this tool.
8
stripped threads and bent thrust cups are not accepted warranty claims on this tool.
© Jack sealey limited
instructions for
trailing arm bush tool-vauxhall/opel
model no:
Wear protective
Gloves
large Adaptor (silver removal)
Small Adaptor (silver removal)
force screw (x2)
flange nut
small Adaptor (black reinstall)
large Adaptor (black reinstall)
Original Language Version
vse4787
fig.1
Vse4787 | issue 1 06/06/16