Table of Contents
Advertisement
Turn the System On with Points Faulted (Force Arm)
Force-arming is not permitted for UL applications.
IMPORTANT
I can perform this command.
I cannot perform this command.
1.
Press [ALL ON] or [PART ON] to turn the system All On or Part On.
2.
The command center displays the faulted points as follows:
Then the system identifies the faulted point (in this example Point 5), followed by instructions for bypassing
the point.
3.
To force arm the system All On or Part On with normal Exit Delay and exit tone, press [ALL ON] or [PART
ON] again. Enter your passcode when prompted. The following scrolls across the display:
Note:
The display above uses an Exit Delay time of 60 sec. and only one point is force-armed. Exit Delay time and the
number of points forced on may vary.
4.
To force arm the system All On or Part On with Exit Delay doubled and no exit tone, press and hold [ALL
ON] or [PART ON] until the "point faulted" message appears (see figure in Step 2). Then press [ALL ON] or
[PART ON] again. Enter your passcode if prompted. The system then scrolls the Forced on! message and
the doubled Exit Delay Time countdown. The exit tone is silenced.
The system 'forces' the faulted points on. As long as they remain faulted they do not provide protection. If the
faulted points return to normal before the system is turned off, they provide protection and are capable of
starting alarm events. If a point becomes faulted after the exit delay begins, the command center displays the
faulted point. If the point remains faulted at the end of exit delay, it starts an alarm event.
© 2003 Bosch Security Systems
Pt5 faulted,
Point Text
To Bypass Pt5
Press 5 + *
Forced on!
60 seconds to
All On.
1 points are
forced on.
D623/D625 User Guide
Page 17
Security System
User Guide
46841D
Advertisement
Table of Contents
