Table of Contents
Advertisement
INITIAL INSTALLATION
1. Place the water cooler upright.
2. Locate the water cooler on a hard and level surface in a
cool shaded location near a grounded wall outlet.
NOTE:
Do NOT plug in the power cord yet.
3. Position the water cooler so the back is at least 4 inches
from the wall and there are at least 4 inches of clearance
on both sides.
4. Level the water cooler as shown below to prevent vibration.
There are two leveling feet at the back of the water cooler.
Please adjust them one at a time until the water cooler sits
level and does not rock. Failure to level the water cooler
can cause vibrational noise when the compressor runs.
NOTE:
Do NOT plug in power cord yet.
5. Make sure the RED power switch is turned OFF. Plug into
a grounded 3 prong outlet.
6. Check if the water filled the hot tank by dispensing water
from the hot water faucet, then turn the RED power switch
ON.
12
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in serious injury, fire or electrical shock.
WARNING
2 leveling feet
Hide quick links:
Advertisement
Table of Contents
