Garden Watering; Interior And Exterior Lighting - Siemens LOGO! 8 Manual

2 Solution
2.3.4

Garden watering

Function description
The LOGO! TDE or the LOGO! display can be used to predefine manual or
automatic control of the garden watering.
In manual mode, the garden watering can be controlled with the cursor keys over
the LOGO! controller and the LOGO! TDE.
In automatic mode, the garden watering is switched on for 10 minutes in the
morning at 09:00 a.m. and in the evening at 08:00 p.m. every day.
The function blocks for the automatic control for garden watering can be called up
in parameter assignment mode with the respective block name using the LOGO!
display or LOGO! TDE. If required, parameters like days and times for garden
watering can be adjusted.
Table 2-10
No.
1. Daily, automatic garden watering
2.3.5

Interior and exterior lighting

Inputs and outputs
Table 2-11
No.
1. Button light on/off room 1
(integrated panic button)
2. Button light on/off room 2
(integrated panic button)
3. Button exterior lighting on/off
(integrated panic button)
4. Central off button
(integrated panic button)
5. Lighting room 1
6. Lighting room 2
7. Exterior lighting
Signals pending at the inputs of a slave LOGO! should normally be pending for
Note
0.5 seconds so the signals can be transferred safely.
Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2,
Function
Hardware
09/2018
Function block
Weekly timer watering
LOGO! module Program inputs/outputs
Slave I1 NI1
(network input 1)
Slave I2 NI2
(network input 2)
Slave I3 NI3
(network input 3)
Slave I4 NI4
(Network input 4)
Slave Q1 NQ1
(Network output 1)
Slave Q2 NQ2
(network output 2)
Slave Q3 NQ3
(network output 3)
Block name in the
program
13