About The Battery Status - Honeywell Thor VM3A User Manual

Vehicle-mounted computer
Hide thumbs Also See for Thor VM3A:
Table of Contents

Advertisement

5. Loosen the fourteen (16) captive M3 screws holding the front panel. Use a #2
6. Carefully lift the front panel away from the device.
7. Note the orientation of the UPS battery. Lift the UPS battery out of the battery
8. Locate the retaining tab on the wiring connector for the UPS battery. Press on
9. Remove the old battery and set it aside.
10. Inspect the battery well to verify the two foam pads are still in place.
11. Align the wiring connector on the new UPS battery with the connector on the
12. Place the UPS battery into the well. Note the orientation of the battery in the
13. Position the front panel so the tab on the back of the front panel lines up with
14. Gently press the front panel into place.
15. Tighten the fourteen (16) captive M3 screws. In the order shown in step 5, use a
16. Reinstall the computer in the dock.
17. When the computer is placed in the powered dock, the UPS battery
18. Press the Power button to turn on the computer.

About the Battery Status

Use the battery icon in the Status bar to see the charge level of your battery.
If you want more detailed information on your battery, such as usage time,
charge remaining on the battery, or battery health information, open the
Settings app
Thor VM3A Vehicle-Mounted Computer
Phillips bit.
well and place it outside the well. Do not pull on the wires attaching the battery
to the computer while lifting the battery.
the tab and gently disconnect the UPS battery wiring.
computer. Gently press the connector into place until the retaining tab snaps
into place.
illustration below. The flat surface of the battery points toward the bottom of
the VM3A. Make sure all wires are inside the battery well so they are not
pinched when the front panel is reinstalled.
the slot on the VM3A. Be sure the two wiring connectors are also aligned.
#2 Phillips bit and torque the screws to 6-7 inch pounds.
automatically reconnects. The UPS battery automatically begins charging from
the powered dock.
and tap Battery.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents