Page 1
NOTE: PERSONAL AND CUSTOM PREFRERENCES WILL BE LOST UPON COMPLETION OF THIS FIRMWARE UPDATE. PLEASE MAKE NOTE OF ANY PREFERENCE SETTINGS PRIOR YOU START WITH THIS FIRMWARE UPDATE. How to upgrade the Software Connect the AC power and turn “ON” the TV set. The USB reader is located on the left or right of the cabinet near the side control/jack assembly as shown in Figure-1.
Page 2
“USB device was connected to TV. Do you want to open Media Player ?” message will be displayed as shown in Figure-3. Figure-3 Use the arrow buttons on the remote controller to select the “NO”. Press the “MENU” button on the remote controller. Use the arrow buttons on the remote controller to select the “Installation”...
Page 3
“Do you want to upgrade software” massage will be displayed as shown in Figure-6. Press “Left Arrow button” on the remote controller to start the upgrade. Software update (USB) During software update, TV will not be available to response any operation for a few minutes.