Advertisement
5.7.
After Stapling
5.7.1. Disconnect air hose.
5.7.2. Remove all staples from the tool.
5.7.3. Put 5-10 drops of pneumatic tool lubricant into the air plug of the tool.
5.8.
Cold Weather Operation
WARNING! DO NOT use a frozen tool. Allow to thaw before using. Moisture in the frozen tool may impede internal components resulting
in the risk of injury and/or tool damage.
5.8.1. When using the tool in cold conditions the tool will cycle slower than usual whilst driving the first staples. The cycle rate will increase as the
tool warms up. Keep the tool warm to prevent reduced cycle rate.
5.9.
Adjusting the exhaust
5.9.1. The direction of the exhaust vent can be changed by turning the top cover, see fig.5.
5.10.
Nail Indicator see fig.6.
5.10.1. The red indicator bars are used to show when the tool needs to be reloaded. When the tool is loaded with a staple strip, the red indicator
bars will no longer be visible in the indicator window. When staple strip is consumed, the red indicator bars will start to become visible.
5.10.2. The tool should be reloaded when the red indicator bar is half way exposed in the indicator window.
6. MAINTENANCE
6.1.
Jam clearing see fig.7
Remove a jammed staple in this order:
6.1.1. Disconnect air hose.
6.1.2. Remove staples from the tool. Failure to do so will cause the fasteners to eject from the front of the tool.
6.1.3. Completely remove the small nose screws (A) and the top nose plate (B) to reveal the jammed staple.
6.1.4. Take care NOT to damage the driver plate, whilst using pliers or a screwdriver if required, to clear the jammed staple.
6.1.5. Put the nose plate (B) back on the nose (C), fastening it with screws (A).
6.1.6. Reconnect the air supply.
6.1.7. Reload the staples.
fig.7
© Jack Sealey Limited
fig.5
Original Language Version
fig.6
SA789.V2 Issue: 1 - 27/02/15
Advertisement
