Racecon - Bosch LTE65 Manual

4 | Tools
4.2.1 Adding the LTE65
4.2.2 Communication Specific Settings
12 / 28

4.2 RaceCon

RaceCon is for configuring and calibrating with Bosch Motorsport devices. For general
RaceCon setup and usage, please refer to the DDU 9 manual on the Bosch Motorsport
website. The information below deals specifically with telemetry setup in an existing Race-
Con project.
In the RaceCon project for your vehicle, insert a telemetry device from the Devices toolbox
by clicking and dragging it into the project window. Please note that in order for this ac-
tion to be available, a data logging device must first be configured in RaceCon. A window
will pop-up for configuring the device. Highlighting the Telemetry icon now in the Race-
Con project should bring up the relevant details about the device in the Properties win-
dow.If this window is not visible in your project, select View Properties.
The name of the device can be changed to LTE65 by right clicking on Telemetry in the
project tree and selecting Rename.
Either a laptrigger channel must be available in the project or the logger must be in "Test-
bench" mode, which is configured via the logger's settings pages, for telemetry to work.
For the MS6/MS7 and logger/display devices, the LapTrigger and Fuel blocks need to be
added to the project to create the channels above.
Ethernet TX Telemetry
To send Ethernet telemetry from a Bosch Motorsport device, the Ethernet telemetry fea-
ture must be active. Excluding cases where older logger firmware versions are used, Ether-
net telemetry is already enabled on Bosch logging devices.
Set Ethernet telemetry settings on the device by opening the Telemetry Settings window.
Telemetry_System_LTE65_Manual Bosch Motorsport