Fujitsu Stylistic 3400 Assembly And Use Instructions page 2

3. Using the four black Phillips screws (with star
lockwashers), secure the cradle to the back
assembly.
4. Secure the circuit card to the two standoffs,
using the two silver screws and the two
washers, with the washers positioned between
the screws and the circuit card (reference
Figure 2).
Figure 2. Mounting the Circuit Card
Installing the keyboard
5. Remove the adhesive backing from the Velcro
strips that are attached to the tray.
6. Carefully position the keyboard over the strips
so that the bottom edge of the keyboard butts
against the lower lip of the tray. Once it is
positioned properly, firmly press the keyboard
onto the Velcro strips to secure it (reference
Figure 3).
Back Assembly
Tiedown #1 (approximate location)
Cradle
Figure 3. Wall Mount Components
4/00
Mounting
Hardware
Circuit Card
Cables
Circuit Card
Velcro
Keyboard
Strips
Tray Assembly
Screw Holes (6 ea.: two on
each side, two on bottom)
Stylistic 3400 is a trademark of Fujitsu PC Corp. © 2000 Fujitsu PC Corp.
Page 2 of 4
7. Route the coiled keyboard cable over the
vertical edge of the tray assembly. Leave
approximately ten coils on the keyboard side
(reference Figure 4)
8. Stretch the coil over the edge of the tray so the
section of cable from the edge of the tray to the
first tie point is uncoiled (reference Figure 4).
9. Tie down the cable at the first tie point using a
Ty-Wrap from the hardware kit. The tie point
is located just below the top edge of the tray
(reference Figure 3 for approximate location).
Clip any excess Ty-Wrap with the cutting
pliers.
10. Plug the keyboard plug into the jack on the
circuit card.
.
Tiedown Point #2
Tiedown Point #1
Uncoiled length
2
Coils on Keyboard
Side of Tray
(approximately ten)
Figure 4. Routing the Keyboard Cable
11. Secure the remaining coil to the second
tiedown using a Ty-Wrap from the hardware
kit. Clip any excess Ty-Wrap with the cutting
pliers.
Installing the AC Adapter
12. Locate the Velcro strip on the right-hand side
of the tray. This is the location at which the AC
Adapter will be installed (reference Figure 5).
13. Remove the adhesive backing from the Velcro
strip on the right-hand side of the tray.
Position the AC Adapter (label side up) over
the Velcro strip with the DC power cord on the
left. Make sure the AC power cord on the right
has enough clearance that it is not tightly
crimped when routed around the adapter.
14. Secure the adapter by firmly pressing it onto
the Velcro.
15. Route the DC power cord through the
cutaway.
Keyboard Plug
4
58-0710-00A