Door Latch Removal; Figure 011-3: Door Lock Torsion Spring - Miele H 408 BM Series Technical Information

H 408x BM
5. Unhook the top arm of the torsion spring by pressing forward and down
(Figure 011-3, Item 2).
6. Remove the torsion spring.

Figure 011-3: Door Lock Torsion Spring

Note:
When installing the torsion spring, do not push the latch upward.
Insert the bottom arm of the torsion spring into the notch on the latch (Figure
011-3, Item 3).
Danger!
After the repair is completed, as a matter of standard practice, check the oven
for a tight seal with a microwave leak detector, paying particular attention to
the door and the housing edges.
4.7

Door Latch Removal

1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the screws securing the appliance lid. Remove the lid.
Danger!
Before performing any service or repair work, discharge the high-voltage
capacitor. See Section A-2.
3. Remove the fascia panel with support plate. See Section 040-4.7.
4. Remove the door safety switches (door lock); see Section 011-4.8.
5. Remove the two screws securing the ducting front corners, if applicable (Figure
011-4, Item 1).
6. Disconnect the connectors on the magnetron thermostat.
7. Remove the two screws securing the magnetron thermostat.
8. Release the magnetron thermostat.
Note: H 4082/4/6/8 BM ovens
do not have the support plate
shown in Figure 011-3.
19
Technical Information