Canon PIXMA MX870 Service Manual page 12

error.
Faulty EEPROM [1405]
data of the print
head.
Multiple ink tanks [1487] U071 More than one ink
of the same color
installed.
Ink tank in a wrong [1680] U072 Some ink tanks are
position.
Warning: The ink [1700]
absorber becomes
almost full.
The connected [2001]
digital camera or
digital video
camera does not
support Camera
Direct Printing.
Automatic duplex [1310]
printing cannot be
performed.
The remaining ink [1683] U130 (Applicable ink
amount unknown
(raw ink present).
Ink tank not [1684] U140 The following ink
recognized.
Ink tank not [1682] U150 The following ink
recognized.
No ink (no raw [1688] U163 The ink has run
ink).
Replace the wrong ink tank(s) with the correct
tank of the one(s).
following color is
installed.
Install the ink tank(s) in the correct position.
not installed in
place.
--- Contact the support Replace the ink absorber, and reset its
center or service counter. [See
center for ink (5) Ink absorber counter
absorber Pressing the OK button will exit the error, and
replacement. Press enable printing without replacing the ink
[OK] to continue absorber. However, when the ink absorber
printing. becomes full, no further printing can be
performed unless the applicable ink absorber
is replaced.
--- Incompatible Remove the cable between the camera and the
device detected. machine.
Remove the
device.
--- This paper is not The paper length is not supported for duplex
compatible with printing.
duplex printing. Press the OK button to eject the paper being
Remove the paper used at error occurrence.
and press [OK]. Data which was to be printed on the back side
of paper at error occurrence is skipped (not
printed).
An ink tank which has once been empty is
tank icon) installed. Replace the applicable ink tank with
The remaining a new one. Printing with a once-empty ink
level of the ink tank can damage the machine.
cannot be correctly To continue printing without replacing the ink
detected. tank(s), press the Stop button for 5 sec. or
longer to disable the function to detect the
remaining ink amount. After the operation, it
is recorded in the machine EEPROM that the
function to detect the remaining ink amount
was disabled.
A non-supported ink tank (an ink tank that is
tank cannot be sold in a different region from where the
recognized. machine was purchased) is installed (the ink
(Applicable ink tank LED is turned off). Install the supported
tank icon) ink tanks.
A hardware error occurred in an ink tank (the
tank cannot be ink tank LED is turned off). Replace the ink
recognized. tank(s).
(Applicable ink
tank icon)
Replace the empty ink tank(s), and close the
out. Replace the scanning unit (cover).
4-5. Special Notes on Servicing,
setting.]
9 / 63
- Ink tank
- Logic board
- Ink tank
- Logic board
- Absorber kit
- PictBridge board
- Logic board
- Duplex feed roller
unit
- PE sensor board
- Logic board
- Ink tank
- Spur unit
- Ink tank
- Logic board
- Ink tank
- Logic board
- Ink tank
- Spur unit