Philips LIGHTOLIER IS-LLAH11 Manual

This luminaire is intended for installation in accordance with the National Electrical Code and local
regulations. To assure full compliance with local codes and regulations, check with your local
electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box
before proceeding. Allow fixture to cool before handling.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR INSTALLING AND OPERATING LLAH11 SERIES TRACK LED LUMINAIRES.
FOR USE WITH LIGHTOLIER LYTESPAN TRACK SYSTEMS ONLY.
- Compatible with ceiling, wall and suspended mounted track. Compatible with multipoint.
- Compatible with monopoint 6173 for the LLAH11 series fixtures. Sold separately.
- Compatible with hex cell louver AL25HC for the LLAH11. Sold separately.
- Compatible with snoot series LLAN01SN for the LLAH11. Sold separately.
- Compatible with LLR reflector series for the LLAH11. Sold separately.
- See specification sheet LED-DIM for compatible dimmers.
- Not compatible with 6170, 6172, 6190 monopoints, extension wands,clamp-on monopoint,
weighted base, sloped ceiling adapter, Atom, pro-spec track.
- CAUTION: HOT SURFACE. Keep away from curtains and any other combustible materials.
- CAUTION: Turn power off and allow fixture to cool before handling.
- CAUTION: No consumer serviceable parts. Contact factory if service is required.
- CAUTION: For use in dry locations only.
INSTRUCTIONS FOR ATTACHING LUMINAIRE TO TRACK.
1. Turn off power to TRACK.
A. ADAPTER: BASIC TRACK (FIG.1)
1. Insert luminaire into TRACK (FIG. 2).
The STEM must be on the same side as the BEAD.
2. Rotate DRIVER HOUSING clockwise 90°, pull DRIVER HOUSING away from
TRACK enough for LEVER to clear TRACK.
3. Turn LEVER to position (FIG 3.) to mechanically secure DRIVER HOUSING.
4. TO REMOVE: Turn LEVER, lightly pull down DRIVER HOUSING,
and rotate counterclockwise.
B. ADAPTER: ADVENT TRACK (FIG. 4)
TO POWER ON UPPER CIRCUIT
1. Raise BRASS CONTACT to high position by pulling CONTACT as high
as stop permits (FIG. 5).
2. Follow instructions above for installing into track.
TO POWER ON LOWER CIRCUIT
1. Ensure CONTACTS are at the same level. Push down BRASS contact if needed.
2. Follow instructions above for installing into track.
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
IS-LLAH11 951463 Rev B Feb-16 page 1 of 4
BRASS
CONTACT
FIG. 5
IS-LLAH11
ALCYON LED
HORIZONTAL
TRACK LIGHTING
LIGHTOLIER ADAPTER
TRACK
NEUTRAL
CIRCUIT
FIG. 1
BASIC TRACK
FIG. 2
FIG. 3
TRACK
UPPER
CIRCUIT
LOWER
CIRCUIT
FIG. 4
ADVENT TRACK
HOT
CIRCUIT
NEUTRAL
CIRCUIT