Hotline; Revisions - AEG AMP 4 Installation Manual


Start your terminal programme. You have to set the following settings: 8 data bits, 1 start bit
und 1 stop bit, no parity check (often called 8N1), baud rate 19200 baud, no flow control(e.g.
XOFF/XON).

Send the command „VER <CR>" to the AMP. The reader answers with the actual firmware
version (e.g. AEG ID AMP8 V1.3).

Change to mode 1 with the command "MO 1" (the default value is MO 2)

With the command "MP 1" .. "MP 8" you can change the antenna channels.
7

Hotline

If there are questions or suggestions please call the hotline:
Sales und Marketing: +49 (0)731-140088-0
Fax: +49 (0)731-140088-9000
e-mail: sales@aegid.de
http://www.aegid.de
8

Revisions

25.01.10
10.12.10
17.02.11
20.01.15
12.06.19
--------------------------------------------------------------------------------18/20--------------------------------------------------------------------------------
Revision 00: Initial revision
Revision 01: Information to power supply added
Revision 02: Information to clean ground added
Revision 03: Pin assignment SAB connector
Revision 04: Text MO and MP